| Problem |
Cause |
Solution |
|
Error message reads –“3
series device not found” |
Low
battery power. |
Replace the batteries |
|
Drivers are not installed. |
Plug in the unit to your
USB Port. Go to your Control
Panel -> System
-> Click the Hardware Tab -> Device Manager.
Find the Item called Ports and double click it. The
USB-Serial device should be listed. If you do not see
it, then turn your unit off and restart your computer
with the 3100 device plugged in and follow the instructions
on Software Installation. |
| |
Contact
Support@skytrx.com for further assistance. |
|
Cannot Find the Power Switch,
Download Port or Battery Compartment |
No Cause |
There is a rectangular
protective cap that is snapped in on the front of the
unit. Push up on the tab and pull the cap from
the unit. You will see the control panel under the rectangular
cap. The battery compartment is opened by removing
the 4 screws on the bottom of the unit. |
|
Error message reads –
“Memory Empty- No downloadable data.” |
Placement with in the vehicle. |
Double check your placement,
ensure that the unit (INT) or GPS antenna (EXT) is facing
upward and that there is no metal about the antenna.
Try a test drive with the unit on your dash board. |
| Low
battery power |
Replace the batteries. |
|
Damaged Antenna plug (EXT’s Only). |
Contact
Support@skytrx.com for further assistance. |
|
The unit will not wake
up from sleep mode or the light turns off right away. |
Low battery power. |
Replace the batteries |
|
Gaps with in the Data |
Placement with in the vehicle. |
Double check your placement,
ensure that the unit (INT) or GPS antenna (EXT) is facing
upward and that there is no metal about the antenna.
Try a test drive with the unit on your dash board. |
| GPS
lock on time. |
After elongated stops it
may take your device 2-3 minutes to lock back on to
the GPS satellites. |
| Low
battery power. |
Replace the batteries |
|
No Maps |
Windows 98 operating system
is being used. |
Contact
Support@skytrx.com for the walkthrough on how to
fix this problem. |
|
Bad tracking data. |
Erase the data that you
have off of your unit and gather some new data. |
|
No Power |
Low
battery power |
Replace the batteries |
|
Polarity on power source is reversed. |
If you are using external
power be sure that your wiring isn’t reversed.
If you are using batteries make sure that are all properly
inserted. |
|
Possible damage. |
Contact
Support@skytrx.com for further assistance. |