GPS Models
    GPS Accessories
    Specifications
    Sample Tracking
    FAQ
    Tracking Basics
    Warranty
    Support Center
    Terms Of Sale
    Privacy Policy
Request Specials
 Name:
 Email:
Sponsors
CallRecorderCard
 
SpyChest
 

 

 

  Home Contact Us Refer A Friend Checkout
 

 

SkyTRX Mini Tracker - MT4100
Placement & GPS Locking

 

READ THIS BEFORE USING THE SkyTRX Mini Tracker.

  1. KNOW HOW GPS WORKS.  The SkyTRX Mini Tracker uses Globally Positioned Satellites to find its location. In order to lock onto the location, the SkyTRX Mini Tracker must have a direct line of sight to 3 locations in the sky and these locations are changing constantly throughout the day.  Make sure that there isn’t any metal completely blocking this upward / outward line of sight.   GPS signals will penetrate plastic, glass, rubber, fiberglass, cloth material, or anything else not made of metal.  The more metal obstructions that are above and around the GPS sensor the longer it will take to lock onto the location (GPS sensor is integrated into the SkyTRX Mini Tracker).  Make sure you choose an optimal location to place the unit for good tracking results.  An example of placement for the Tracking Key is the glove box but depending on the design of the vehicle, it may take longer to lock onto the location.  If the glove box is very low inside the vehicle with a lot of obstructions, it may not be able to track.  In this case you will have to find a better location to place the GPS unit.

 

  1. TAKE A TEST DRIVE (VERY IMPORTANT).  Take the unit for a test run with the GPS unit on your dashboard for at least a few miles (10-15 min).  When you place batteries inside the unit, it is considered a cold start.  It can take 2 minutes or more for a cold start.  If you leave batteries in the unit there will not be another cold start until you replace the batteries. After 3 minutes of inactivity, the unit will go into a very low power mode which will not drain the batteries.  Now download your test data by following the Quick Start Guide for Downloading Data.

Unit Placement

Location of the GPS Unit

Effectiveness

Comments

On the front or rear dash board

99%

Probably one of the best locations to keep your unit if you do not need to conceal the device. You can place the unit in a box of tissues or in something on the dash.
Under the Front or Rear Dash Board

95%

It is important to remember that the unit must be high enough up in the dash board to make an effective lock. Spotty data will indicate that your placement may need to be adjusted.
In the Glove Box

80-95%

This is good location to keep your unit.  Effectiveness may vary from one vehicle to another, but if placed properly it should work in the glove box of almost any vehicle.
Under or on the Seat.

70%

Placement under the seat will vary from vehicle to vehicle.  If you must place the unit under the seat, make sure you test it for a day or two to make sure it will work in your vehicle.
Under the Vehicle

70%

Placement under the vehicle will vary from vehicle to vehicle.  If you must place the unit under the seat, make sure you test it for a day or two to make sure it will work in your vehicle. SkyTRX does not guarantee that the SkyTRX Mini Tracker will work in this location. If the unit is not properly gathering data you may have to adjust your location.

Notice

Our tracking devices may not be used to violate the privacy rights of others, or in violation of local, county, state or federal statutes. GPS tracking may be illegal in certain states. In no way will www.skytrx.com, or parent company Spy Chest Inc or its subsidiaries or partners be held responsible for inappropriate use of these products.

IT IS THE SOLE RESPONSIBILITY OF THE BUYER TO CONSULT LEGAL COUNSEL FOR THE INTERPRETATION OF ANY LAWS APPLICABLE TO THE AREA OF INTENDED USE OF THESE PRODUCTS.

 
sdfdsf